Knight Wall Systems, the Deer Park, Wash., maker of rainscreen cladding supports, has a new bracket meant for walls that aren't as straight as the drawings say. The company announced ADJUSTAKLIP on Nov. 9, describing it as a thermally improved cladding support with built-in in-and-out adjustment (via Knight Wall Systems).
The main pitch is tolerance. The bracket gives up to 1-1/2 inches of adjustment at the rail, and shims can be added beyond that. The L-rail can sit fully nested so it lines up with the face of the insulation, then get pulled outward as needed to true up the cladding plane. An adjustment indicator on the bracket shows when an installer has reached the maximum, which the company says helps keep proper engagement.
Brian Nelson, Knight's director of sales, engineering and marketing, said in the release: "And it easily corrects wall irregularities to achieve a consistent cladding plane."
On the specs side, the system handles wall assemblies up to 8-1/2 inches deep and can run rails vertically or horizontally. It goes over steel studs, wood studs, CMU and concrete, and the brackets come pre-punched for anchors. Knight says mineral wool insulation fits snugly around the bracket with little trimming, and that both the bracket and the L-rail are non-combustible.
The company rates it for cladding loads up to 25 pounds per square foot, a figure the release marks with an asterisk without explaining the condition. It also claims corrosion resistance up to 10 times that of G90 galvanized steel. Finishes are black or stainless steel.
You can buy the bracket alone or as a full package with rails, thermally isolated wall anchors, fasteners and project-specific engineering. Knight's FAQ says that engineering is a structural analysis stamped by a professional engineer licensed in the project's jurisdiction, and that it sells direct rather than through dealers. The 10-year limited warranty applies when Knight does the engineering and supplies the anchors; otherwise its standard coverage is one year for defective material. The release doesn't list pricing or say where the product is made.
ADJUSTAKLIP joins an existing lineup that includes Knight's CI, HCI and MFI cladding support systems. The CI system, for example, uses vertical box girts over rigid insulation and is also rated to 25 psf.
Why the fuss over clips? Every bracket that passes through exterior insulation is a path for heat. A technical bulletin from building science firm RDH Building Science notes that continuous Z-girts can leave exterior insulation only 20 to 60 percent effective, while thermally isolated clip systems typically land in the 60 to 90 percent range. Energy codes including the IECC and ASHRAE 90.1 expect designers to account for that loss, which is why the attachment choice ends up in code compliance.
Why it matters for Contractors
This is mostly a commercial and multifamily facade product, the kind of thing an architect specifies on a panel or rainscreen job. Most small residential remodelers won't run into it on a typical siding job.
If you're a smaller siding or exterior subcontractor who picks up rainscreen work on light commercial or mixed-use buildings, though, the adjustment range is the part to notice. Out-of-plumb walls are where installers lose time shimming, and a bracket designed to take up that slop could save labor. Ask whether the warranty requires Knight's engineering and anchors before you substitute anything in the field.