Issues The Feed
Hello Contractor News

CMI fiberboard and cant strip now cost 6% to 8% more on every shipment

Continental Materials raised fiberboard and cant strip prices 6% to 8% on all shipments from Nov. 2, regardless of order date. What roofers should check.

Roofers who buy fiberboard or cant strip from Continental Materials are now paying more. The Abington, Pa., roofing components supplier announced Oct. 13 that prices on all of its fiberboard and cant strip and tapered edge products would rise 6% to 8% nationwide, effective with shipments on Nov. 2 (via CMI).

The key detail is how the company drew the line. The increase applies to anything that ships on or after Nov. 2, regardless of when it was ordered. CMI told customers that already-priced fiberboard orders and job quotes had to ship before Nov. 2 to keep the old pricing. That window has closed, so any open order or quote that hadn't shipped by then should now be priced at the new rate.

The company blamed rising costs for energy, materials and transportation. It didn't say how the 6% to 8% range breaks down by product or region, so the exact change on what you buy will show up on your supplier's new pricing. CMI customer service, at 1-800-247-6637, handles special job quotes and revised pricing.

Both products show up on a lot of low-slope work. According to CMI's product pages, its fiberboard can be used in asphalt and single-ply roof systems and as a recovery board, adding R-value and stiffening foam insulation and the roof deck. It's made from 100% recycled or reclaimed material. Cant strip and tapered edge smooth the 90-degree angle where a roof meets a wall or parapet, ease transitions from tapered insulation to roof level or up to a nailer, and help water drain off instead of ponding.

CMI describes itself as a national supplier of roofing system components. Its line also includes coatings, packaged asphalt, roofing nails and fasteners, underlayments, weather barriers, tapes and sealants and modified bitumen. This notice covers only the fiberboard and cant strip and tapered edge products.

Why it matters for Contractors

If you do flat or low-slope roofing, re-roofs over existing decks, or porch and addition roofs that tie into a wall, this hits a part of the job that's easy to overlook in a bid. Check any quotes you sent before November that include fiberboard, recovery board or cant strip, and see whether they were priced on the old numbers. If the materials haven't shipped, you're likely paying the new price. Call your supplier for updated pricing, adjust open bids, and keep quote expiration dates short. The dollar amounts on these components are usually small, but on a tight commercial or multifamily roof bid, 6% to 8% on every board adds up, and it's one more line where a supplier's cost bump can quietly come out of your margin.